NetSDRWideband Digital RadioUser’s GuideFirmware Revision 1.07 & 1.08FPGA Revision 3 & 4

InstallationThe NetSDR uses an ethernet connection to the PC for communications. The NetSDR can be connected directly to a PC or it can connect to a r

The Default gateway and DNS servers should not be populated when using direct communications. When using a router with a built-in DHCP server, the Net

SDRNetSetup SoftwareRFSPACE supplies the SDRNetSetup application in the CD Rom. This application can be used to find all of the NetSDR and SDR-IP radio

SDR-Radio SoftwareThe new SDR-Radio software by SDR-RADIO.com GmbH supports the NetSDR. This exciting new ap-plication allows the control of the NetSD

CuteSDR Open Source ApplicationRFSPACE supplies a simple, open-source application for the NetSDR radio. This application is written using the QT frame

Interface SpecificationsPlease contact [email protected] for the latest version of the NetSDR Interface Specification Document.

ComplianceThis equipment has been tested and found to comply with the limits for a Class B digital device as appli-cable, pursuant to Part 15 of the F

Table of ContentsLegal Notices!! ! ! ! ! 3Supplied Accessories! ! ! ! 4!Precautions! ! ! ! ! ! 5Hardware! ! ! ! ! ! 6Introduction! ! ! ! ! ! 7Front Pa

Legal NoticesThis User Guide provides user information and is provided “as is.” RFSPACE and its affiliated companies, directors, officers, or employees

Supplied AccessoriesThe NetSDR ships with a universal (multi-plug) power supply, ethernet cable, and SpectraVue software installation CD. The user gui

PrecautionsCAUTION! There are no user replaceable parts inside. CAUTION! Never put the receiver in any unstable place . This may cause damage to the

Hardware• Frequency range: 0.010 - 32.000 MHz, 1Hz Steps * Usable up to 34 MHz+• DDC Processor: Xilinx XC3S500E • PC Interface: Ethernet 100 base-T (U

IntroductionThe NetSDR radio is a high performance networked SDR with 1.6 MHz bandwidth and 2.0 MHz output sample rate. The NetSDR uses a high perform

Front PanelPower button: Turns NetSDR on/offClip LED: Shows the analog to digital converter clipping state. When on, the ADC is experiencing a signal

Rear PanelRF IN (RF 1): Main RF input (0.010 - 34.000MHz). Input AC coupled . Do not exceed 13dBm or 25 VDC.REF: 10 MHz reference input in units equip